![]() With a soft texture, this fine finish produces beautifully smooth textured walls and is usually the preferred choice for private homes. Rustic Finishes: Noise Reduction Coefficient (NRC): 0.10 NRC: Sound Absorption Coefficient: 0.090N Smooth and Tonal Finish: Noise Reduction Coefficient (NRC): 0.10 NRC: Sound Absorption Coefficient: 0.090Nĭemi-Rustic Finishes: Noise Reduction Coefficient (NRC): 0.10 NRC: Sound Absorption Coefficient: 0.090N Smooth and Tonal Finish: 0.1162 Kg CO2 eq/Kg Rustic Finishes: 1.5 m² (at 6-7 mm thick)Ĭoarse Rustic Finishes: 1 m² (at 8-12 mm thick) Smooth and Tonal Finish: 7-8 m² (at 2 mm thick)ĭemi-Rustic Finishes: 2.6 m² (at 4-5 mm thick) Rustic Finishes: BS EN 520 – Impact Diameter < 15mm Smooth and Tonal Finish:BS EN 520 – Impact Diameter < 15mmĭemi-Rustic Finishes:BS EN 520 – Impact Diameter < 15mm Observe the same protocol as for conventional plaster using picture hooks or screws. On textured surfaces, such as the Arakabe or Sculpted, cleaning should be carried out with due care and attention avoiding rough treatment of the surface. Wipe gently with a soft, damp sponge, if it has been finished previously with Clayworks protective glaze. Low, even heat can be used in cold conditions, but must be used with caution as it can cause hairline cracks in the plaster if it dries too quickly.Īpplication should not proceed when temperatures fall below 5 degrees centigrade or rise above 30 degrees centigrade. Good air circulation is encouraged during and after application. In ideal conditions, the plaster should be fully dry within 24 hours. Can be painted with micro-porous paint.ĭependent on ambient conditions in the room and rates of absorption from the background material. Please see our guidance notes for detailed application guidelines, downloadable from our website Finishingīest finished with Clayworks protective glaze for maximum damage resistance. This is often a more suitable finishing approach for undulating surfaces. ![]() However, an open grained, more textured finish can be achieved using a damp sponge to loose trowel marks. This is achieved by hard polishing with a plastic trowel or a Japanese Trowel. A smooth finish is preferred for durability and cleaning. Application is similar to gypsum with the exception of the finishing process. Can also be applied with a spray machine. Applied in the conventional manner with a hawk and laying on trowel. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |